Crown QMS Especificaciones descargar pdf (Pagina 124)

Testing PC-Printer

Communication

QMS magicolor 2 Op

eration8-14

Testing PC-Printer

Communication

To test communication between your printer and your PC, first create

a short file that ejects a page from the printer. Then send the file to

the printer.

Creating the Test File

To create the test file, type the following commands at the DOS

prompt:

copy con printest.ps↵

showpage↵

^D^Z↵

(All commands above except the DOS copy command are case sen-

sitive and must be typed exactly as shown.) Showpage is a PostScript

command that prints a blank page. The ↵ symbol means to press the

Enter key. To produce the ^D and ^Z, press and hold down the Ctrl

key while you type the appropriate letters (d and z). These characters

signify the end of the file and must always be included.

Sending the Test File

Parallel Communication

1 To send the PRINTEST.PS file (you just created) to the

printer, type

copy /b printest.ps lpt#↵

where # is the port number (1 to 3).

» Note:

If the computer has more than one parallel port, they're

probably labeled. If not, check the computer documentation for

the LPT port names.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 187 188

Sin comentarios

Crown QMS Especificaciones Pagina 124